Dell PowerEdge R710 Series Hardware Owner's Manual page 50

Table 1-2. System Messages (continued)
Message
Unable to launch
System Services
image. System
halted!
Unexpected
interrupt in
protected mode
Unsupported CPU
combination
Unsupported CPU
stepping
detected
Unsupported DIMM
detected. The
following DIMM
has been
disabled: x
Unsupported
memory
configuration.
DIMM mismatch
across slots
detected:
x , x , ...
50
About Your System
Causes
System halted after F10
keystroke because System
Services image is either
corrupted in the system
firmware or has been lost
due to system board
replacement.
The iDRAC6 Enterprise card
flash memory may be
corrupted.
Improperly seated memory
modules or faulty
keyboard/mouse controller
chip.
Processor(s) is not supported
by the system.
Invalid memory
configuration. The system
will run but with the
specified memory module
disabled.
Invalid memory
configuration. Memory
modules are mismatched in
the specified slots.
Corrective Actions
Restart the system and
update the Unified Server
Configurator repository to
the latest software to restore
full functionality. See the
Unified Server Configuration
user documentation for more
information.
Restore the flash memory
using the latest version on
support.dell.com. See the
iDRAC6 user's guide for
instructions on performing a
field replacement of the flash
memory.
Reseat the memory modules.
See "Troubleshooting System
Memory." If the problem
persists, see "Getting Help."
Install a supported processor
or processor combination.
See "Processors."
Ensure that the memory
modules are installed in a
valid configuration. See
"General Memory Module
Installation Guidelines."
Ensure that the memory
modules are installed in a
valid configuration. See
"General Memory Module
Installation Guidelines."