Dell PowerEdge R710 Series Hardware Owner's Manual page 44

Table 1-2. System Messages (continued)
Message
Memory odd/even
logic failure at
address, read
value expecting
value
Memory
write/read
failure at
address , read
value expecting
value
Memory set to
minimum
frequency.
Memory tests
terminated by
keystroke.
MEMTEST lane
failure
detected on
Mirror mode
disabled. For
mirror mode,
DIMMs must be
installed in
pairs. Pairs must
be matched in
size and
geometry.
44
About Your System
Causes
Faulty or improperly
installed memory modules.
Faulty or improperly
installed memory modules.
The memory frequency may
be intentionally set lower for
power conservation.
The current memory
configuration may support
only the minimum
frequency.
POST memory test was
terminated by pressing the
spacebar.
Invalid memory
configuration. A
mismatched memory
x
module is installed.
The memory configuration
does not match the setting
in BIOS. The BIOS setting
has been disabled.
Corrective Actions
See "Troubleshooting System
Memory."
See "Troubleshooting System
Memory."
If not an intentional setting,
check any other system
messages for possible causes.
Ensure that your memory
configuration supports the
higher frequency. See
"General Memory Module
Installation Guidelines."
Information only.
Ensure that the memory
modules are installed in a
valid configuration. See
"General Memory Module
Installation Guidelines."
Reconfigure the memory
modules for Memory
Mirroring mode. See "System
Memory."