Dell PowerEdge R710 Series Hardware Owner's Manual page 113

Figure 3-20. Installing a Storage Controller Card
1
8
1 dedicated storage controller card
connector
3 integrated storage controller card
5 SAS_1 connector
7 SAS_0 connector
3 Slide the storage controller's card edge connector into the card slot on the
riser until the card is fully seated. See Figure 3-20.
4 Connect the SAS_0 cable to the storage controller's SAS_0 connector, and
connect the SAS_1 cable to the controller's SAS_1 connector.
NOTE:
cable. The cables are not operational if reversed.
5 For a battery-cached PERC controller, install the RAID battery. See
"Installing a RAID Battery."
2
7
Be sure to connect the cable according to the connector labels on the
3
4
2 riser 1
4 RAID battery connector (PERC only)
6 connector locking tabs
8 card edge guides (2)
Installing System Components
5
6
113