Dell PowerEdge R710 Series Hardware Owner's Manual page 105

7 If not already done, connect the power and interface cables from the
optical drive to the system board connectors.
Connect the power cable to the DVD/TBU_PWR connector on the
a
front of the system board below the fan bracket. See Figure 6-2 for the
location of the connector.
Route the interface cable along the inside right wall of the chassis. See
b
"Cable Routing" and Figure 3-16 for the 2.5-inch backplane chassis or
Figure 3-17 for the 3.5-inch backplane chassis.
Connect the cable to the SATA_A connector on the system board. See
c
Figure 6-2 for the location of the connector.
8 Close the system. See "Closing the System."
9 Replace the bezel. See "Installing the Front Bezel."
10 Reconnect your system and peripherals to their electrical outlets, and turn
on the system.
Figure 3-15. Removing and Installing the Optical Drive
1 optical drive
3 power cable
1
2
4
Installing System Components
2
optical-drive interface cable
optical-drive release tab
3
4
105