Table of Contents
Advertisement
Base I/O address
Available addresses include "378h" (the default),
"228h," "278h," and "3BC."
Interrupt
Available IRQs include "IRQ7" (the default) and
"IRQ5."
NOTE
An interrupt set to IRQ5 in a multimedia
system might
conflict with the audio subsystem
settings.
DMA Channel
Available DMA settings include "DMA 3" (the
default), and "DMA 1." The DMA field is only
displayed when the Mode field is set to "ECP."
T
Floppy Disk Controller
This field enables the diskette drive interface connector
on the riser board. Choices include "Enabled" (the
default) or "Disabled."
T
IDE Controller
The IDE Controller field enables the IDE interface
connectors on the riser board. Choices include "Both"
(default), "Primary," "Secondary," and "Disabled."
T
Audio
This field ("Enabled" by default) enables the audio
system on the system board. Choose "Disabled" if an
audio board is installed.
T
Hardware Monitor
This field ("Enabled" by default) enables the hardware
monitor device.
Using Tools and Utilities 4-15
Advertisement
Table of Contents
