Table of Contents
Advertisement
Replace the system unit cover (see "Replacing the
7.
Covers"). Connect system power cables and external
options.
8.
Power on the system. The BIOS Setup utility launches
immediately after POST, and no password is required.
The Maintenance menu is active.
9.
Select the Clear All Passwords field. Press Enter.
A Setup Confirmation window appears with the
10.
prompt, "Clear All Passwords Now?" The default is
Yes. Press the left or right arrow key to toggle between
Yes and No. Select Yes and press Enter to activate the
choice.
Power off and unplug the system and any external
11.
options. Remove the system unit cover (see "Removing
the Covers").
Loosen the drive cage screws at the rear of the system
12.
unit. Swing the drive cage out of the interior of the
system unit.
13.
Move the J7E1 jumper back to pins 1 and 2 so the
system can restart in normal operation mode.
14.
Swing the drive cage back into the system unit.
Replace the screws that hold the drive cage to the rear
of the chassis.
Replace the system unit cover (see "Replacing the
15.
Covers"). Connect system power cables and external
options.
Power on the system and launch the BIOS Setup utility
16.
before POST to set a new password (see "Setting a
Password") and re-customize your BIOS settings.
Setting Jumpers 6-7
Advertisement
Table of Contents
