Table of Contents
Advertisement
The system power must be off before changing a
jumper setting.
3.
Remove the left system unit cover (see "Removing the
Covers").
4.
Loosen the drive cage screws at the rear of the system
unit. Swing the drive cage out of the interior of the
system unit.
5.
Locate the J7E1 jumper block on the system board (see
"Locating Jumpers on the System Board").
Move the jumper to pins 2 and 3. This jumper setting
6.
brings the system up in Configure mode when it is
rebooted.
Swing the drive cage back into the system unit.
7.
Replace the screws that hold the drive cage to the rear
of the chassis.
8.
Replace the left system unit cover (see "Replacing the
Covers"). Connect system power cables and external
options.
9.
Power on the system. The BIOS Setup utility launches
immediately after POST displaying the Maintenance
menu.
Select the Processor Speed field. Press
10.
11.
A subwindow appears displaying the supported
processor speeds. Use the up or down arrow key to
select the correct processor speed. Press Enter.
Select the Exit menu with the left or right arrow key.
12.
Press Enter to exit saving changes. Press Enter again to
confirm that you wish to exit the BIOS Setup utility.
6-4 Setting Jumpers
!
WARNING
.
Enter
Advertisement
Table of Contents
