Table 7: Dynamic Qos Profiles - SMC Networks SMCGS10P-SMART Management Manual

In MAC-based Authentication mode, the switch will ignore new frames
coming from the client during the hold time.
RADIUS-Assigned QoS Enabled - RADIUS-assigned QoS provides a
◆
means to centrally control the traffic class to which traffic coming from
a successfully authenticated supplicant is assigned on the switch. The
RADIUS server must be configured to transmit special RADIUS
attributes to take advantage of this feature.
The RADIUS-Assigned QoS Enabled checkbox provides a quick way to
globally enable/disable RADIUS-server assigned QoS Class
functionality. When checked, the individual port settings determine
whether RADIUS-assigned QoS Class is enabled for that port. When
unchecked, RADIUS-server assigned QoS Class is disabled for all ports.
When RADIUS-Assigned QoS is both globally enabled and enabled for a
given port, the switch reacts to QoS Class information carried in the
RADIUS Access-Accept packet transmitted by the RADIUS server when
a supplicant is successfully authenticated. If present and valid, traffic
received on the supplicant's port will be classified to the given QoS
Class. If (re-)authentication fails or the RADIUS Access-Accept packet
no longer carries a QoS Class or it's invalid, or the supplicant is
otherwise no longer present on the port, the port's QoS Class is
immediately reverted to the original QoS Class (which may be changed
by the administrator in the meanwhile without affecting the RADIUS-
assigned setting).
This option is only available for single-client modes, i.e. port-based
802.1X and Single 802.1X.
RADIUS Attributes Used in Identifying a QoS Class
The User-Priority-Table attribute defined in RFC4675 forms the basis for
identifying the QoS Class in an Access-Accept packet.
Only the first occurrence of the attribute in the packet will be
considered. To be valid, all 8 octets in the attribute's value must be
identical and consist of ASCII characters in the range '0' - '3', which
translates into the desired QoS Class in the range 0-3.
QoS assignments to be applied to a switch port for an authenticated
user may be configured on the RADIUS server as described below:
The "Filter-ID" attribute (attribute 11) can be configured on the
■
RADIUS server to pass the following QoS information:

Table 7: Dynamic QoS Profiles

Profile Attribute Syntax
DiffServ service-policy-in=policy-map-name service-policy-in=p1
Rate Limit rate-limit-input=rate
802.1p switchport-priority-default=value
Multiple profiles can be specified in the Filter-ID attribute by using a
■
semicolon to separate each profile.
– 81 –
| Configuring the Switch
C 4
HAPTER
Configuring Security
Example
rate-limit-input=100
(in units of Kbps)
switchport-priority-default=2