Specifying Authentication Servers; Figure 37: Configuring Static Bindings For Arp Inspection - SMC Networks SMCGS10P-SMART Management Manual

Enter the required bindings for a given port.
3.
Click Save.
4.

Figure 37: Configuring Static Bindings for ARP Inspection

Use the Authentication Server Configuration page to control management
S
PECIFYING
access based on a list of user names and passwords configured on a
A
UTHENTICATION
RADIUS or TACACS+ remote access authentication server, and to
S
ERVERS
authenticate client access for IEEE 802.1X port authentication (see
page
N
OTE
been configured to support AAA. The configuration of RADIUS and
TACACS+ server software is beyond the scope of this guide. Refer to the
documentation provided with the RADIUS and TACACS+ server software.
P
ATH
Configuration, Security, Network, AAA
P
ARAMETERS
These parameters are displayed:
Common Server Configuration
◆ Timeout – The time the switch waits for a reply from an authentication
server before it resends the request. (Range: 3-3600 seconds;
Default: 15 seconds)
Dead Time – The time after which the switch considers an
◆
authentication server to be dead if it does not reply.
(Range: 0-3600 seconds; Default: 300 seconds)
Setting the Dead Time to a value greater than 0 (zero) will cause the
authentication server to be ignored until the Dead Time has expired.
However, if only one server is enabled, it will never be considered dead.
RADIUS/TACACS+ Server Configuration
Enabled – Enables the server specified in this entry.
◆
IP Address – IP address or IP alias of authentication server.
◆
77)
This guide assumes that RADIUS and TACACS+ servers have already
:
– 109 –
| Configuring the Switch
C 4
HAPTER
Configuring Security