Figure 24: Snmpv3 View Configuration - SMC Networks SMCGS10P-SMART Management Manual

| Configuring the Switch
C 4
HAPTER
Configuring Security
W I
EB NTERFACE
To configure SNMPv3 views:
Click Configuration, Security, Switch, SNMP, Views.
1.
Click "Add new view" to set up a new view.
2.
Enter the view name, view type, and OID subtree.
3.
Click Save.
4.

Figure 24: SNMPv3 View Configuration

C SNMP 3 G
ONFIGURING V
Use the SNMPv3 Access Configuration page to assign portions of the MIB
tree to which each SNMPv3 group is granted access. You can assign more
than one view to a group to specify access to different portions of the MIB
tree.
P
ATH
Configuration, Security, Switch, SNMP, Access
P
ARAMETERS
These parameters are displayed:
Group Name - The name of the SNMP group. (Range: 1-32 characters,
◆
ASCII characters 33-126 only)
Security Model - The user security model. (Options: any, v1, v2c, or
◆
the User-based Security Model – usm; Default: any)
Security Level - The security level assigned to the group:
◆
NoAuth, NoPriv - There is no authentication or encryption used in
■
SNMP communications. (This is the default for SNMPv3.)
Auth, NoPriv - SNMP communications use authentication, but the
■
data is not encrypted.
Auth, Priv - SNMP communications use both authentication and
■
encryption.
Read View Name - The configured view for read access. (Range: 1-32
◆
characters, ASCII characters 33-126 only)
– 74 –
A R
ROUP CCESS IGHTS