Figure 70: Configuring Ingress Port Qos Classification - SMC Networks SMCGS10P-SMART Management Manual

QoS Ingress Port Tag Classification
Tag Classification – Sets classification mode for tagged frames on
◆
this port:
Disabled – Uses the default QoS class and DP level for tagged
■
frames. (This is the default.)
Enabled – Uses the mapped versions of PCP and DEI for tagged
■
frames.
PCP/DEI – Shows the mapping options for classified (PCP, DEI) to
◆
(QoS class, DP level) values when Tag Classification is Enabled.
QoS class – Controls the mapping of classified (PCP, DEI) to QoS class
◆
values when Tag Classification is Enabled. (Range: 0-7; Default: 0)
DP level – Controls the mapping of classified (PCP, DEI) to DP level
◆
(drop precedence) values when Tag Classification is Enabled.
(Range: 0-1; Default: 0)
W I
EB NTERFACE
To set the basic QoS parameters for a port:
Click Configuration, QoS, Port Classification.
1.
Set any of the ingress port QoS classification parameters.
2.
Click Save.
3.

Figure 70: Configuring Ingress Port QoS Classification

To configure tag classification for tagged frames:
Click Configuration, QoS, Port Classification.
1.
Click on the value displayed in the Tag Class field.
2.
– 177 –
| Configuring the Switch
C 4
HAPTER
Quality of Service