Configuring User Privilege Levels; Figure 13: Configuring User Accounts - SMC Networks SMCGS10P-SMART Management Manual

Figure 13: Configuring User Accounts

Use the Privilege Levels page to set the privilege level required to read or
C U
ONFIGURING SER
configure specific software modules or system settings.
P L
RIVILEGE EVELS
P
Configuration, Security, Switch, Privilege Levels
P
These parameters are displayed:
◆
◆
ATH
ARAMETERS
Group Name – The name identifying a privilege group. In most cases,
a privilege group consists of a single module (e.g., LACP, RSTP or QoS),
but a few groups contains more than one module. The following
describes the groups which contain multiple modules or access to
various system settings:
System: Contact, Name, Location, Timezone, Log.
■
Security: Authentication, System Access Management, Port
■
(contains Dot1x port, MAC based and the MAC Address Limit), ACL,
HTTPS, SSH, ARP Inspection, and IP source guard.
IP: Everything except for ping.
■
Port: Everything except for VeriPHY.
■
Diagnostics: ping and VeriPHY.
■
Maintenance: CLI - System Reboot, System Restore Default,
■
System Password, Configuration Save, Configuration Load and
Firmware Load. Web - Users, Privilege Levels and everything in
Maintenance.
Debug: Only present in CLI.
■
Privilege levels – Every privilege level group can be configured to
access the following modules or system settings: Configuration Read-
only, Configuration/Execute Read-write, Status/Statistics Read-only,
and Status/Statistics Read-write (e.g., clearing statistics).
The default settings provide four access levels:
1 – Read access of port status and statistics.
■
– 57 –
| Configuring the Switch
C 4
HAPTER
Configuring Security