Table of Contents
Advertisement
2 Hardware Installation
Step 1 Connect the Line interface of the device to the MODEM interface of the splitter through a telephone cable.
Connect the phone to the PHONE interface of the splitter through a telephone cable. Connect the
incoming line to the LINE interface of the splitter.
The splitter has three interfaces:
LINE: Connect to a wall phone jack (RJ-11 jack).
MODEM: Connect to the ADSL jack of the device.
PHONE: Connect to a telephone set.
Step 2 Connect the LAN interface of the device to the network interface card (NIC) of the computer through an
Ethernet cable (MDI/MDIX).
I
Note:
Use twisted-pair cables to connect with the hub or switch.
Step 3 Plug one end of the power adapter to the wall outlet and connect the other end to the Power interface of
the device.
Connection 1
Figure 1 displays the application diagram for the connection of the router, computer, splitter and the telephone sets,
when no telephone set is placed before the splitter.
Figure 1 Connection diagram (Without connecting telephone sets before the splitter)
Connection 2
Figure 2 displays the connection when the splitter is installed close to the router.
5
Advertisement
Table of Contents
