Hardware Installation - SMC Networks Barricade SMC7004AWBR User Manual

Hardware Installation

2.1 Panel Layout
2.1.1. Front Panel
LEDs monitor the status of each port.
Figure 2-1 Front Panel LED
LED Function Colour
POWER Power indication Green
M1 System status 1 Orange
M2 System status 2 Orange
WAN WAN port activity Green
W.LAN Wireless activity Green
Link/Act. Link status Green
1~3
SPEED Data Rate Green
1~3
Status Description
On Power is being applied
to this product.
Blinking This product is
functioning properly.
On This product is working
for a specific service.
Blinking This product is being
configured or upgraded.
Don't turn it off !
On The WAN port is linked.
Blinking The WAN port is sending
or receiving data.
Blinking Sending or receiving data
via wireless
On An active station is
connected to the
corresponding LAN port.
Blinking The corresponding LAN port
is sending or receiving data.
On Data is transmitting in
100Mbps on the
corresponding LAN port.
2.1.2. Rear Panel
The rear panel features three 10/100 Mbps Ethernet ports and one
Wide Area network (WAN) port. The WAN port connects your DSL or
cable modem to the router. The LAN ports are used to connect to
your computers or other network devices.
Figure 2-2 Rear Panel Ports
Port Description
RESET To reset system settings to factory defaults,
please follow the steps:
1. Power off the device,
2. Press the reset button and hold,
3. Power on the device,
4. Keep the button pressed about 5 seconds,
5. Release the button,
6. Watch the M1 and M2 LEDs, they will flash
8 times and then M1 flashes once per second.
PRINTER Printer Port (Optional)
COM Serial port (connect dial-up modem or console cable)
WAN Port The port where you will connect your cable (or DSL)
modem or Ethernet router.
Port 1-3 The ports where you will connect networked
computers and other devices.
DC IN Power inlet (DC 12V)