Table of Contents
Advertisement
Field
Update
Delete Selected
Show Routes
Static Route Table
Click Show Routes, the table as shown in the following figure appears. The table shows a list of destination routes
commonly accessed by your network.
3.7.4.2 RIP
Click RIP, and the page as shown in the following figure appears. If the device is used as a RIP-enabled router to
communicate with other devices by using Routing Information Protocol (RIP), you need to enbale RIP. In this page,
you can configure the parameters of RIP, including the interface, receiving version, transmitting version.
The following table describes the parameters and buttons in this page:
Field
RIP
Apply Changes
interface
Receive Mode
Select a row in the Static Route Table and modify the parameters. Then click it to save
the settings in this page .
Select a row in the Static Route Table and click it to delete the row.
Click it, the IP Route Table appears. You can view a list of destination routes commonly
accessed by your network.
A list of the previously configured static IP routes.
Select Enable, the router communicates with other RIP-enabled devices.
Click it to save the settings in this page.
Select the interface of the router that uses RIP.
Select the interface version that receives RIP messages. You can select None,
RIP1, RIP2, or Both.
Description
Description
42
Advertisement
Table of Contents
