Hardware Installation; Network Settings And Software Installation - SMC Networks BR14VPN - annexe 3 Manual

SMCBR18VPN Front Panel: 8 LAN, 1 WAN, and 1 COM port
Port Type
5 VDC
WAN
Port 1–4/8
COM

5 | Hardware Installation

The router can be placed anywhere in your office or home. No special wiring or cooling
requirements are necessary. However, you should comply with the following guidelines:
• Place your router on a flat, horizontal surface
• Be sure to place your router away from any heating devices
• Avoid dusty and/or humid areas
1) Setup LAN Connection: Connect an Ethernet cable from your computer's Ethernet port
to one of the LAN ports of the router.
2) Step WAN Connection: Insert one end of the Ethernet cable into the WAN port on the
back panel of your router, and the other end to the cable/DSL modem. You may connect
an analog modem (optional) to function as a backup connection.
3) Power Up: The router automatically enters the self-testing phase once the power cord
is plugged into a wall outlet. When in self-testing phase, the M1 indicator LED illuminates
for about five seconds to indicate proper connection. The M1 LED flashes twice as soon
as the self-testing phase is completed. After the completion of the self-testing phase, the
M1 LED should flash once per second to indicate that the router is functioning properly.

6 | Network Settings and Software Installation

IP Address
Subnet Mask
Administrator Password
User Password
4
Description
Receptor for power adapter:
5 VDC, 2 A (minimum)
This is the connection for the Ethernet cable to the
Ethernet port on the cable or DSL modem
These are the connections for Ethernet cables to
your Ethernet enabled computers
Serial port (connection for an analog modem or
console cable)
Default Settings
192.168.2.1
255.255.255.0
smcadmin
password