Table of Contents
Advertisement
Field
Send Mode
Add
Delete Selected Entry
RIP Configuration Table
3.7.5
IP QoS
Choose Advanced > IP QOS, and the page as shown in the following figure appears. Entries in this table are used
to assign the precedence for each incoming packet according to physical LAN port, TCP/UDP port number, source
IP address, destination IP address, and other information.
The procedure for configuring quality of service (QoS) is as follows:
Step 1 Enable IP QoS and click Apply to enable IP QoS.
Step 2 Click add rule to add a new IP QoS rule.
The page as shown in the following figure appears.
None indicates that the router does not receive RIP message.
RIP1 indicates that the router receives RIP V1 messages.
RIP2 indicates that the router receives RIP V2 messages.
Both indicates that the router receives RIP V1 and RIP V2 messages.
Select the working mode for sending RIP messages. You can select None, RIP1
RIP2, or RIP1 COMPAT.
RIP1 indicates that the router broadcasts RIP1 messages only.
RIP2 indicates that the router multicasts RIP2 messages only.
Click it to add a specified RIP interface to the RIP Configuration Table.
Select a row in the RIP Configuration Table and click it to delete the row.
A list of the router interfaces that enble RIP.
43
Description
Advertisement
Table of Contents
