Table of Contents
Advertisement
Field
Set the encryption mode to WEP, and click Set WEP Key. The page as shown in the following figure appears.
The following table describes the parameters in this page:
Field
Key Length
Key Format
Default Tx Key
Encryption Key 1 to Key 4
3.5.3
Advance Settings
Choose WLAN > Advance Settings, and the page as shown in the following figure appears. In this page, you can
configure the wireless advanced parameters. It is recommended to keep the default values.
Note:
The parameters in the Wireless Advance Settings page are modified by the professional engineer, it is
recommended to keep the default values.
be the same on the external authentication server and your router.
Select the WEP key length. You can select 64-bit or 128-bit.
If the key length is set to 64-bit, you can select ASCII (5 characters) or
Hex (10 characters).
If the key length is set to 128-bit, you can select ASCII (13 characters) or
Hex (26 characters).
Select the index of WEP Key. You can select Key 1, Key 2, Key 3, or Key 4.
The encryption keys are used to encrypt the data. Both the router and wireless
stations must use the same encryption key for data transmission.
If you select 64-bit and ASCII (5 characters), enter any 5 ASCII characters.
If you select 64-bit and Hex (10 characters), enter any 10 hexadecimal
characters.
If you select 128-bit and ASCII (13 characters), enter any 13 ASCII
characters.
If you select 128-bit and Hex (26 characters), enter any 26 hexadecimal
characters.
27
Description
Description
Advertisement
Table of Contents
