Table of Contents
Advertisement
Field
Bridge
AC-Name
Service-Name
Apply Changes
Return
Undo
Click ATM Settings in the WAN Interface page, and the page as shown in the following figure appears. In this
page, you can configure the parameters of ATM, including QoS type, PCR, CDVT, SCR and MBS.
The following table describes the parameters in this page:
Field
VPI
VCI
QoS
PCR
CDVT
SCR
MBS
assaigned by DHCP.
If you select Static IP, you need to manually enter the IP address for
PPPoE dail-up.
You can select Bridged Ethernet, Bridged PPPoE, or Disable Bridge.
Enter the accessed equipment type.
Enter the service name.
Click it to save the settings in this page.
Click it to return to the WAN Interface page.
Click it to refresh this page.
The virtual path identifier of the ATM PVC.
The virtual channel identifier of the ATM PVC.
The QoS category of the PVC. You can select UBR, CBR, rt-VBR, or
nrt-VBR.
Peak cell rate (PCR) is the maximum rate at which cells can be transmitted
along a connection in the ATM network. Its value ranges from 0 to 6000.
Cell delay variation tolerance (CDVT) is the amount of delay permitted
between ATM cells (in microseconds). Its value ranges from 0 to
4294967295.
Subtain cell rate (SCR) is the maximum rate that traffic can pass over a PVC
without the risk of cell loss. Its value ranges from 1 to 6000.
Maximum burst size (MBS) is the maximum number of cells that can be
transmitted at the PCR. Its value ranges from 0 to 65535.
34
Description
Description
Advertisement
Table of Contents
