Table of Contents
Advertisement
The following table describes the parameters and buttons in this page:
Field
IP QoS
Source IP
Source Netmask
Destination IP
Destination Netmask
Source Port
Destination Port
Protocol
Physical Port
Outbound Priority
QoS Tag
IP Precedence
IP ToS
802.1p
Delete Selected
Delete All
Disable or enable QoS. By default, IP QoS is disabled. You need to enable IP QoS,
and then you can configure the parameters in this page.
Enter the IP address of the source data packet.
Enter the subnet mask of the source IP address.
Enter the IP address of the destination data packet.
Enter the subnet mask of the destination IP address.
Enter the port of the source data packet.
Enter the port of the destination data packet.
The protocol responds to the IP QoS rules. You can select TCP, UDP, or ICMP.
The LAN interface responds to the IP QoS rules, including four LAN interfaces, one
AP interface, and four VAP interfaces.
The priority of the IP QoS rules. P0 is the highest priority and P3 is the lowest.
Select the checkbox to enable QoS tag.
Set the priority in the ToS of the IP data packet. The priority is in the range of 0 to 7.
The type of IP ToS for classifying the data package
You can select Normal Service, Minimize Cost, Maximize Reliability, Maximize
Throughput, or Minimize Delay.
The priority is in the range of 0 to 7.
Select a row in the IP QoS Rules and click it to delete the row.
Select all the rows in the IP QoS Rules and click it to delete the rows.
Description
44
Advertisement
Table of Contents
