Table of Contents
Advertisement
The following table describes the parameters in this page:
Field
Current ATM VC Table
VPI
VCI
Encapsulation
Channel Mode
Admin Status
Enable NAPT
PPP Settings
Login Name
Password
Connection Type
This table shows the existed PVCs. It shows the interface name, channel mode,
VPI/VCI, encapsulation mode, local IP address, remote IP address, and other
information. The maximum item of this table is eight.
Click it, the PPP/Briged/IP Interface-Modify page appears. You can modify
the PVCs' parameters.
VPI is the virtual path between two points in an ATM network. Its valid value
is in the range of 0 to 255.
VCI is the virtual channel between two points in an ATM network. Its valid
value is in the range of 32 to 65535. (0 to 31 is reserved for local management
of ATM traffic)
You can select LLC and VC-Mux.
You can select 1483 Bridged, 1483 MER, PPPoE, PPPoA, or 1483 Routed.
Select Disable, and then this PVC is unusable.
Select the checkbox to enable the Network Address Port Translation (NAPT)
function of the router. If you do not select it and you want to access the
Internet normally, you must add a route on the uplink equipment. Otherwise,
the access to the Internet fails. Normally, it is required to enable NAPT.
Enter the correct user name for PPP dial-up, which is provided by your ISP.
Enter the correct password for PPP dial-up, which is provided by your ISP.
You can select Continuous, Connect on Demand, or Manual.
Continuous: After dial-up is successful, PPP connection is always on-line,
no matter whether the data is being transmitted or not.
It is recommended to select it.
Connect on Demand: After dial-up is successful, within the preset idle
31
Description
Advertisement
Table of Contents
