Snmp Version 3 User; Snmp Trap; Snmp Trap Mode - SMC Networks 7824M/VSW - annexe 1 Manual

Management Guide
TigerAccess™ EE
7.1.7
7.1.8
7.1.8.1
!
SMC7824M/VSW
To display a granted SNMP group to access to a specific SNMP view record, use the fol-
lowing command.
Command
show snmp access

SNMP Version 3 User

In SNMP version 3, you can register an SNMP agent as user. If you register an SNMP
version 3 user, you should configure it with the authentication key. To create/delete an
SNMP version 3 user, use the following command.
Command
snmp user USER {md5 | sha}
AUTH_KEY [des PRIVATE_KEY]
no snmp user USER
To display a current SNMP version 3 user, use the following command.
Command
show snmp user

SNMP Trap

SNMP trap is an alert message that SNMP agent notifies SNMP manager about certain
problems. If you configure the SNMP trap, the system transmits pertinent information to
network management program. In this case, trap message receivers are called a trap
host.

SNMP Trap Mode

To select the SNMP trap mode, use the following command.
Command
snmp trap-mode {alarm-report |
event}
• "event" trap-mode is set by default. It generates event based traps.
• "alarm-report" trap-mode generates alarm report based traps.
If you manage the system via the ACI-E, you should set the SNMP trap mode to the
alarm-report.
Mode
Enable
Shows a granted SNMP group to access to a specific
Global
SNMP view record.
Bridge
Mode
Creates an SNMP version 3 user.
Global
Deletes a registered SNMP version 3 user.
Mode
Enable
Global Displays an SNMP version 3 user.
Bridge
Mode
Selects the SNMP trap mode.
Global alarm-report: alarm report based trap
event: event based trap (default)
Description
Description
Description
Description
CLI
139