Removing The Display-Feed Flex Cable (12.1-Inch Display Panel) - Dell LATITUDE Latitude C600 Service Manual

36 Re m o vi n g a n d Re p l a c i n g Par ts

Removing the Display-Feed Flex Cable (12.1-Inch Display Panel)

D i s p l a y - Fe e d F l e x C a b l e
bottom flex
pull tab
cable connector
inverter
connector
NOTICE: Disconnect the computer and any attached devices from electrical
outlets, and remove any installed batteries.
NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or
by touching an unpainted metal surface on the computer.
NOTICE: Read "Preparing to Work Inside the Computer" before performing
the following procedure.
Remove the hard drive.
1
Remove the display assembly.
2
Remove the display assembly bezel.
3
Remove the four M3 x 3-mm screws that secure the display panel to
4
the support bracket (see "12.1-Inch Display Assembly Bezel and
Panel").
Lift the bottom of the display panel out of the display-assembly top
5
cover.
top flex
cable connector
display panel
connector