Replacing The Memory Modules; Mini-Pci Card Assembly - Dell LATITUDE Latitude C600 Service Manual

20 Re m o vi n g a n d Re p l a c i n g Par ts
NOTICE: Read "Preparing to Work Inside the Computer" before performing
the following procedure.
Remove the memory module cover.
1
To release a memory module from its socket, spread apart the inner
2
tabs of the memory module socket just far enough for the memory
module to disengage from the socket. The module should pop up
slightly.
Lift the memory module out of its socket.
3

Replacing the Memory Modules

If you only have one memory module, install it in the socket labeled
1
"JDIM1." Install a second memory module in the socket labeled
"JDIM2."
NOTE: Memory modules are keyed, or designed to fit into their sockets,
in only one direction.
NOTICE: The memory module must be inserted at a 45-degree angle to avoid
damaging the connector.
Align the memory module's edge connector with the slot in the center
2
of the memory module socket. With the module at a 45-degree angle,
press the memory module's edge connector firmly into the memory
module socket.
Pivot the memory module down until it clicks into place. If you do not
3
hear a click, remove the memory module and reinstall it.
Insert the tabs on the memory module cover into the bottom case
4
assembly. Rotate the memory module cover down and tighten the two
captive screws.

Mini-PCI Card Assembly

You must remove the optional mini-PCI card assembly before the system
board assembly can be removed. A mini-PCI card assembly may consist of a
modem, a NIC, a modem and NIC combination, or a wireless NIC. A
modem, NIC, or modem and NIC combination must be connected to the
wiring harness as appropriate; a wireless NIC must be connected to the
system's internal antenna.