Removing The Display Panel Brackets; Removing The Display Panel Cable - Dell Latitude D630 Service Manual

5. Lift the display panel a few inches from the top cover.
6. Draw the display cable pull-tab away from the top cover to release the display cable, and lift the display panel fully from the top cover.
Removing the Display Panel Brackets
CAUTION:
CAUTION:
surface, such as a connector on the back of the computer.
1. Follow the instructions in
2. Remove the display assembly (see
3. Remove the display bezel (see
4. Remove the display panel (see
5. Remove the four M2 x 3-mm screws from each side of the display panel.
1 display
panel
Removing the Display Panel Cable
CAUTION:
CAUTION:
surface, such as a connector on the back of the computer.
1. Follow the instructions in
2. Remove the display assembly (see
3. Remove the display bezel (see
4. Remove the display panel (see
5. Turn over the display panel and place it on a clean surface.
NOTICE:
as you reseat the bottom flex-cable connector. Do not bend the inverter board.
6. Gently pull the pull-tab on the bottom flex-cable connector to release the cable from the inverter board.
7. Squeeze the flex-cable release levers at either side of the top flex-cable connector to release the connector.
Great user manuals database on
Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
Before You Begin.
Display Assembly).
Removing the Display
Removing the Display
2 display panel brackets (2) (left and
right of display panel)
Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
Before You Begin.
Display Assembly).
Removing the Display
Removing the Display
To avoid damage to the computer when replacing the bottom flex cable, gently support the bottom of the inverter board with one finger
UserManuals.info
Bezel).
Panel).
3 M2 x 3-mm screws (4 each on
sides of display panel)
Bezel).
Panel).