Removing The Mini-Pci Card Assembly; Replacing The Mini-Pci Card Assembly - Dell LATITUDE Latitude C600 Service Manual

22 Re m o vi n g a n d Re p l a c i n g Par ts

Removing the Mini-PCI Card Assembly

NOTICE: Disconnect the computer and any attached devices from electrical
outlets, and remove any installed batteries.
NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or
by touching an unpainted metal surface on the computer.
NOTICE: Read "Preparing to Work Inside the Computer" before performing
the following procedure.
Remove the memory module cover.
1
To release the mini-PCI card assembly from its socket, spread apart the
2
metal securing tabs until the assembly pops up slightly.
Lift the mini-PCI card assembly out of its socket and disconnect any
3
attached cables.

Replacing the Mini-PCI Card Assembly

NOTICE: The mini-PCI card must be inserted at a 45-degree angle to avoid
damaging the connector.
NOTICE: The mini-PCI card is keyed, or designed to fit into its socket, in only
one direction. Do not force the connection.
Align the mini-PCI card with the socket at a 45-degree angle, and press
1
the mini-PCI card firmly into the socket.
Depending on the type of mini-PCI card you are installing, either
2
connect the interface cables to the mini-PCI card, or connect the
mini-coax antenna cable from the mini-PCI card to the internal
antenna.
Lower the mini-PCI card until it snaps into the metal securing tabs.
3
NOTE: If you are installing a wireless NIC, fold and tuck the unused
interface cables into the slot so they do not interfere with the cover.
NOTE: A modem-only mini-PCI card has one connector; place the unused
NIC connector under the mini-PCI card.
Replace the memory module cover.
4