Removing The 12.1-Inch Display Assembly Bezel; Removing The 12.1-Inch Display Panel - Dell LATITUDE Latitude C600 Service Manual

34 Re m o vi n g a n d Re p l a c i n g Par ts

Removing the 12.1-Inch Display Assembly Bezel

NOTICE: Disconnect the computer and any attached devices from electrical
outlets, and remove any installed batteries.
NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or
by touching an unpainted metal surface on the computer.
NOTICE: Read "Preparing to Work Inside the Computer" before performing
the following procedure.
Remove the hard drive.
1
Remove the display assembly.
2
Use the scribe to pry the six rubber screw covers out of the screw holes
3
located on the bezel on the front of the display assembly.
Remove the six M2.5 x 5-mm screws located on the bezel on the front
4
of the display assembly.
NOTICE: To avoid damage to the bezel, do not bend the bezel while
separating it from the display-assembly top cover.
Use a plastic scribe to carefully separate the bezel from the
5
display-assembly top cover.

Removing the 12.1-Inch Display Panel

NOTICE: Disconnect the computer and any attached devices from electrical
outlets, and remove any installed batteries.
NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or
by touching an unpainted metal surface on the computer.
Remove the hard drive.
1
Remove the display assembly.
2
Remove the display assembly bezel.
3
Remove the hinge covers.
4
Remove the four M3 x 3-mm screws on the front of the display panel
5
that secure the display panel to the support bracket.
Remove the M2 x 4-mm screw that secures the display-feed flex cable
6
to the display assembly through the black plastic flex cable retention
bracket (see "12.1-Inch Display Assembly Bezel and Panel").