The Accelerator Control - APRILIA LEONARDO 150 - 2006 Manual

T h e e n g i n e m i n i m u m r p m m u s t b e
approximately the following:
! "
1400 ± 50 rpm;
√
#
1500 ± 100 rpm;
√
1450 ± 100 rpm.
√
300
In this case the engine does not make the
rear wheel rotate.
If necessary:
! "
Act on the adjusting screw (1)
positioned on the carburettor.
#
Act on the adjusting screw (2)
300
positioned on the carburettor.
By SCREWING IT (clockwise), you
increase the engine rpm.
By UNSCREWING IT (anticlockwise),
you decrease the engine rpm.
300
Act on the throttle grip, accelerating and
decelerating a few times to make sure
that it functions correctly and to check if
the idling speed is constant.
NOTE
Do not act on the air adjusting
s c r e w , t o a v o i d v a r i a t i o n s o f t h e
carburation setting.
If necessary, contact your aprilia Official
Dealer.
ADJUSTING

THE ACCELERATOR CONTROL

Carefully read p. 39 (MAINTENANCE).
The idle stroke of the throttle grip must be
2 – 3 mm, measured on the edge of the
grip itself.
If this is not the case, proceed as follows:
Position the vehicle on the centre stand.
Withdraw the protection element (3).
Loosen the lock nut (4).
Rotate the adjuster (5) in such a way as
to restore the prescribed value.
After the adjustment, tighten the lock nut
(4) and check the idle stroke again.
Put back the protection element (3).
!
WARNING
After the adjustment, make sure that the
rotation of the handlebar does not
modify the engine idling rpm and that
the throttle grip returns smoothly and
automatically to its original position
after being released.
use and maintenance Leonardo 125 - 150 - 250 - 300
55