Setting Push Buttons - APRILIA ETV MILLE CAPONORD ABS - 2003 Manual

SETTING PUSH BUTTONS

WARNING
The operations described below must
be carried out with the vehicle at rest.
Performing these operations while the
vehicle is running may be cause of acci-
dents.
NOTE
The following information is to be
considered as referred to the vehicle at rest.
When the ignition key (1) is turned to the
≈ ∆ (ON) position, on the dashboard within
three seconds:
√ all the warning lights LED come on;
√ all the dashboard lighting LEDs come
on;
√ all the segments appear on the left dis-
play;
√ all the segments and writings appear on
the right multifunction display;
√ the pointers of the indicators move to the
bottom of the indicator range;
38
use and maintenance ETV mille Caponord ABS
thus testing the operation of LEDs, writ-
ings, segments and instruments.
After three seconds, the red engine oil
pressure warning light LED ≈
mains on on the dashboard (and will re-
main on until the engine is starts) and the
following will appear on the displays:
√ total number of miles (3) that the vehicle
has traveled since new;
√ fuel quantity (4);
√ air temperature (5);
√ coolant temperature (6) [up to 35 °C
(95°F) the writing ≈---∆ is displayed];
√ hour and minutes (7).
ADJUSTING THE DASHBOARD
LIGHTING
It is possible to select three different levels
for the dashboard lighting: 100%; 60%;
25%.
For the adjustment, proceed as follows:
◆
Move the dimmer switch ≈
the low beam ≈
NOTE
Three seconds after the last se-
lection, the push button SET returns to the
∆ (2) re-
switching mode total/partial miles odometer.
◆
Turn the ignition key (1) to the ≈ ∆ (ON)
position and, within three seconds, press
the push button SET (9) in sequence,
thus obtaining the three lighting levels.
◆
Select the desired lighting level.
SWITCHING FROM km/mi, °C/°F
The switching:
– km/mi;
– °C/°F;
is set and fixed by aprilia in the vehicle
production phase, according to the
country of destination.
This setting cannot be modified succes-
sively.
- ∆ (8) to
∆ position.
CAUTION