APRILIA ETV MILLE CAPONORD ABS - 2003 Manual page 146

NOTE
Working from the right upperside
(A) of the rear part of the fairing.
For the left low/high beam bulb only:
◆
Move to the left side of the vehicle.
◆
Rotate the handlebar completely coun-
terclockwise (leftwards).
NOTE
Working from the left upperside
(B) of the rear part of the fairing.
CAUTION
To extract the bulb electric connector,
do not pull its electrical wires.
◆
Grasp the bulb electric connector (3) pull
it and disconnect it from the bulb (1).
◆
Pull back the rubber boot (4) with your
fingers.
◆
Release the two ends of the clip (5) posi-
tioned at the rear of the bulb socket (6).
◆
Remove the bulb (1) from the seat.
146
use and maintenance ETV mille Caponord ABS
NOTE
Be sure to maintain the same ori-
entation as the old bulb when you install
the new bulb. Do not try to force the bulb, it
will go easily if it is properly oriented.
◆
Correctly install the new bulb into its
socket, ensuring that the tabs (7) are
correctly positioned.
◆
Replace the two ends of the clip (5) in
them seat.
◆
Replace the rubber boot (4).
◆
Connect the bulb electric connector (3).
PARKING LIGHT BULB (CENTRAL UP-
PER POSITION)
◆
Move to the left side of the vehicle.
◆
Rotate the handlebar completely coun-
terclockwise (leftwards).
NOTE
Working from the central lower-
side (C) of the rear part of the fairing.
CAUTION
While removing a bulb socket, do not
pull on the electrical wires.
◆
Grasp the bulb socket (8), pull it and re-
move it from its seat.
◆
Remove the parking light bulb (2) and re-
place it with an identical bulb.
NOTE
Ensure that the bulb is correctly
inserted in the bulb socket.
◆
Insert the bulb socket (8) in its seat.