Controls; Controls At The Left Hand Grip; Controls At The Right Hand Grip - APRILIA ETV MILLE CAPONORD ABS - 2003 Manual

CONTROLS

NOTE
The electrical components function only when the igni-
tion switch (A) is in the ≈ ∆ (ON) position.
The parking lights are illuminated as well when the ignition
switch (A) is in the ≈ ∆ (PARKING) position.

CONTROLS AT THE LEFT HAND GRIP

1) HORN PUSH BUTTON (
The horn sounds when the button is pressed.
2) DIRECTION INDICATOR SWITCH (
To activate the left turn indicator, move the switch to the left.
To activate the right turn indicator, move the switch to the
right. To cancel the turn indicator flashing, press the switch.
40
use and maintenance ETV mille Caponord ABS
)
)
3) DIMMER SWITCH (
√
The dimmer switch has two positions:
√ low beam ≈ ∆ position;
√ high beam ≈ ∆ position.
When the button is in the position indicated by the ≈
ing lights, dashboard light and low beam are illuminated.
When the button is in the position indicated by the ≈
high beam is illuminated, the dashboard and parking lights re-
main on.
Push the button in the ≈
≈ ∆.
4) HIGH BEAM SIGNALING PUSH BUTTON (
Press the button momentarily to flash the high beam for sig-
naling when passing, etc. or in the event you need someone»s
attention in an emergency.

CONTROLS AT THE RIGHT HAND GRIP

5) ENGINE STOP SWITCH [
Use the engine stop switch to stop the engine only in case of
emergency. It is essential that you be very familiar with this
control so that you will automatically stop the engine in the
event of a stuck throttle or other engine runaway.
WARNING
If the throttle sticks open, it may cause a collision with an-
other vehicle, or an upset.
If the throttle sticks, kill the engine with the engine stop
switch located on the right handlebar.
Do not attempt to restart the engine until the throttle has
been repaired and works perfectly. Failure to obey this
)
∆, the park-
∆ position to return to the low beam
)
(ON) – (OFF)]
∆, the