ZyXEL Communications ZYWALL USG 1000 - EDITION 2 Manual page 422

Chapter 23 Authentication Policy
Figure 306 Configuration > Auth. Policy > Add
The following table gives an overview of the objects you can configure.
Table 109 Configuration > Auth. Policy > Add
LABEL
Create new
Object
Enable Policy
Description
User
Authentication
Policy
Source
Address
Destination
Address
422
DESCRIPTION
Use to configure any new settings objects that you need to use in this
screen.
Select this check box to activate the authentication policy. This field is
available for user-configured policies.
Enter a descriptive name of up to 60 printable ASCII characters for the
policy. Spaces are allowed. This field is available for user-configured
policies.
Use this section of the screen to determine which traffic requires (or does
not require) the senders to be authenticated in order to be routed.
Select a source address or address group for whom this policy applies.
Select any if the policy is effective for every source. This is any and not
configurable for the default policy.
Select a destination address or address group for whom this policy
applies. Select any if the policy is effective for every destination. This is
any and not configurable for the default policy.
ZyWALL USG 1000 User's Guide