Figure 5-1 Menu 11.6 For Vc-Based Multiplexing; Figure 5-2 Menu 11.6 For Llc-Based Multiplexing Or Ppp Encapsulation - ZyXEL Communications PRESTIGE 650H-13 User Manual

Prestige 650H ADSL Router
VC Options for IP:
VPI #= 0
VCI #= 35
ATM QoS Type= UBR
Peak Cell Rate (PCR)= 0
Sustain Cell Rate (SCR)= 0
Maximum Burst Size (MBS)= 0
LLC-based Multiplexing or PPP Encapsulation
For LLC-based multiplexing or PPP encapsulation, one VC carries multiple protocols with protocol
identifying information being contained in each packet header.
Menu 11.6 - Remote Node ATM Layer Options
VPI/VCI (LLC-Multiplexing or PPP-Encapsulation)
.

Figure 5-2 Menu 11.6 for LLC-based Multiplexing or PPP Encapsulation

In this case, only one set of VPI and VCI numbers need be specified for all protocols. The valid range for
the VPI is 0 to 255 and for the VCI is 32 to 65535 (1 to 31 is reserved for local management of ATM
traffic).
The following figure uses sample IP addresses to help you understand the field of My Wan Addr in menu
11.3. Refer to the previous figure LAN and WAN IPs for a brief review of what a WAN IP is. My WAN
Addr indicates the local Prestige WAN IP while Rem IP Addr indicates the peer WAN IP.
5-2
Menu 11.6 - Remote Node ATM Layer Options
VPI/VCI (VC-Multiplexing)
Press ENTER to Confirm or ESC to Cancel:

Figure 5-1 Menu 11.6 for VC-based Multiplexing

VPI #= 0
VCI #= 35
ATM QoS Type= UBR
Peak Cell Rate (PCR)= 5400
Sustain Cell Rate (SCR)= 0
Maximum Burst Size (MBS)= 0
ENTER here to CONFIRM or ESC to CANCEL:
VC Options for Bridge:
VPI #= 1
VCI #= 36
ATM QoS Type= N/A
Peak Cell Rate (PCR)= N/A
Sustain Cell Rate (SCR)= N/A
Maximum Burst Size (MBR)= N/A
Separate VPI and
VCI numbers
must be specified
Only one set of
VPI and VCI
numbers needs to
be specified.
Remote Node TCP/IP Configuration