Table of Contents
Advertisement
Remote Node TCP/IP Configuration
This chapter shows a sample LAN-to-LAN application and how to configure TCP/IP remote node.
5.1
TCP/IP Configuration
The following sections describe how to configure the TCP/IP parameters of a remote node.
5.1.1 Editing TCP/IP Options
Follow the steps ahead to edit Menu 11.6 – Remote Node ATM Layer Options.
In Menu 11.1, move the cursor to the Edit ATM Options, then press [SPACE BAR] to toggle and set the
value to Yes. Press [ENTER] to open Menu 11.6 – Remote Node ATM Layer Options.
There are two versions of Menu 11.6 for the Prestige , depending on whether you chose VC-based or LLC-
based multiplexing and PPP encapsulation in Menu 11.1.
VC-based Multiplexing
For VC-based multiplexing, by prior agreement, a protocol is assigned a specific virtual circuit, e.g., VC1
will carry IP, VC2 will carry IPX, etc. Separate VPI and VCI numbers must be specified for each protocol.
VC Options for IP:
VPI #= 10
VCI #= 10
Peak Cell Rate (cell/sec)= 5500
Sustain Cell Rate (cell/sec)= 0
Maximum Burst Size (cell)= 0
Remote Node TCP/IP Configuration
Menu 11.6 - Remote Node ATM Layer Options
Press ENTER to Confirm or ESC to Cancel:
Press Space Bar to Toggle.
Figure 5-1 Menu 11.6 for VC-based Multiplexing
VC Options for IPX:
VPI #= 11
VCI #= 11
Peak Cell Rate (cell/sec)= 5500
Sustain Cell Rate (cell/sec)= 0
Maximum Burst Size (cell)= 0
VC Options for Bridge:
VPI #= 12
VCI #= 12
Peak Cell Rate (cell/sec)= 5500
Sustain Cell Rate (cell/sec)= 0
Maximum Burst Size (cell)= 0
Prestige 782R G.SHDSL Router
Chapter 5
Separate VPI and
VCI numbers
must be specified
for each protocol.
5-1
Advertisement
Table of Contents
