Sherwood NewCastle R-772 Operating Instructions Manual page 9

R-772(A) 2007.8.16 5:21 PM 페이지 9
6.
CONNECTING DIGITAL INS AND OUT
• The OPTICAL and the COAXIAL DIGITAL OUTs
of the components that are connected to this unit
can be connected to these DIGITAL INs.
• A digital input should be connected to the
components such as a CD player, DVD player,
etc. capable of outputting DTS Digital Surround,
Dolby Digital or PCM format digital signals, etc.
• If the component with OPTICAL IN jack is
connected to the OPTICAL OUT jack of this unit,
you can record the high quality sound of CDs, etc.
without degradation.
• For details, refer to the operating instructions of
the component connected.
• When making the COAXIAL DIGITAL connection,
be sure to use a 75 Ω COAXIAL cord, not a
conventional AUDIO cord.
• All of the commercially available optical fiber cords
cannot be used for the equipment. If there is an
optical fiber cord which cannot be connected to your equipment, consult your dealer or nearest service
organization.
Notes:
�
• Be sure to make either a OPTICAL or a COAXIAL DIGITAL connection on each component. (You don't need to
do both.)
• Depending on the digital audio signal format input into HDMI IN connector, some digital signals cannot be
output from the OPTICAL OUT jack.
� � Digital input default settings
• If you connect the DIGITAL INs to your components, it is easier to do so following the default settings.
• If your DIGITAL connections are different from default settings, you should assign the DIGITAL INs you used
with the "When selecting the AUDIO ASSIGN" procedure on page 54.
• The default settings are as follows :
OPTICAL IN 1 : VIDEO 1, OPTICAL IN 2 : VIDEO 2, COAXIAL IN 1 : CD, COAXIAL IN 2 : AUX.
7.
CONNECTING DC TRIGGER OUT
• Connect a component to DC TRIGGER OUT jack
that allows DC 12V to turn on when a specific
input source is selected.
• For details, refer to the operating instructions of
the components to be connected.
• To link DC TRIGGER OUT with a specific input
source, refer to "When selecting the DC
TRIGGER" on page 55.
Notes:
�
• This output voltage (12V d.c., 100mA) is for (status) control only, it is not sufficient for drive capability.
• When making DC TRIGGER connection, you should use the stereo mini cord, not a mono mini cord.
8.
CONNECTING SUBWOOFER PREOUT
• To emphasize the deep bass sounds, connect a
powered subwoofer.
9