Sherwood NewCastle R-772 Operating Instructions Manual page 35

R-772(A) 2007.8.16 5:21 PM 페이지 35
Continued
� � To cancel the surround mode for stereo operation
� � 2CH downmix mode
• This mode allows the multi-channel signals encoded in DTS or Dolby Digital format, etc. to be mixed down into
2 front channels and to be reproduced through only two front speakers or through headphones.
• When the SPEAKER button is set to off to listen with headphones, if the STEREO button is pressed while
playing the multi-channel digital signals from DTS or Dolby Digital sources, etc., it will enter the 2CH downmix
mode automatically.
• To cancel the 2CH downmix mode, select the Dolby Headphone mode with using the MULTI CONTROL knob
on the front panel or the SURROUND MODE UP/DOWN ( >/< ) buttons on the remote control.
Listening in Dolby Headphone mode
• The Dolby Headphone function simulates 5.1 channel surround sound, which allows you to enjoy 5.1 channel
surround sound through 2 channel headphones, just like listening from 5.1 channel speakers.
�Note :
• Only when the SPEAKER button is set to off, the Dolby Headphone mode can be selected.
• Switch the speakers off to listen with headphones.
Adjusting each channel level with test tone
• The volume level of each channel can be
adjusted easily with the test tone function.
�Note : When the SPEAKER button is set to off,
the test tone function does not work.
1.
Enter the test tone mode.
• The test tone will be heard from the speaker of
each channel for 2 seconds as follows:
Front Left Center
Subwoofer Surround Left
•
When the speaker setting is "NO", the test tone of the
corresponding channel is not available.
• ( ) : Possible depending on whether the surround
back channel is set to "2 CH" or "1 CH".
• Depending on the signal format which is being input, either the stereo
mode or the 2CH downmix mode is selected.
• To cancel either the stereo mode or the 2CH downmix mode, select
the surround mode with using the MULTI CONTROL knob on the
front panel or the SURROUND MODE UP/DOWN ( >/< ) buttons on
the remote control.
• Then "DOLBY HEADPHONE" (or "DOLBY H ~ ") is displayed and
the Dolby Headphone mode is selected.
• To cancel the Dolby Headphone mode, press the SPEAKER
button again.
Front Right Surround Right
Surround Back Surr.Back Left Surr.Back Right
2.
At each channel, adjust the level as desired until
the sound level of each speaker is heard to be
equally loud.
• You can select the desired channel with pressing
the CONTROL UP/DOWN (▲/▼) buttons or the
CURSOR UP/DOWN (▲/▼) buttons.
3.
Cancel the test tone function.
35