Sherwood NewCastle R-772 Operating Instructions Manual page 22

R-772(A) 2007.8.16 5:21 PM 페이지 22
Programing the commands from other
remote controls (LEARNING mode)
• If the setup codes are not available for your
component or you want to program a missing or
special function into one button of a device, the
learning function enables this remote control to
learn the commands from other remote controls.
1.
Place this remote control and other remote
control facing each other at a distance of 5 to 15
cm (2 to 6 inches ) apart.
2.
Press and hold down the ENTER button and the
desired one of the DEVICE buttons for more
than 2 seconds.
• Then "LEARN" is displayed on the LCD screen
for several seconds
�Note :
• During setting operation, to exit from the setting
mode, press any of the DIVICE buttons.
3.
While "LEARN" is displayed, press the ENTER
button.
• Then "SEL" is flickering.
• If "SEL" goes off, start again from the above
step 2.
4.
While "SEL" is flickering, on this remote control,
press the button corresponding to the function to
be learned.
Example: If the function to be learned is playback,
press the PLAY(▶) button.
• Then "READY" is displayed.
�Note:
• You cannot program a function into some buttons
such as DEVICE, MACRO and LIGHT buttons.
5.
While "READY" is displayed, on the other
remote control, press the button of the function
to be learned.
• If the command has been learned successfully,
"OK" is displayed and then "SEL" is flickering.
• If "ERROR" is displayed and then "SEL" is
flickering, it means that for some reason the
command was not learned. In this case, repeat
the above steps 4 and 5.
�Notes :
• If an incorrect signal has been sent or, in some
cases, the command from other remote control
simply cannot be learned.
• In some "ERROR" cases, the remote controls just
need to be moved closer together or farther
apart.
6.
While "SEL" is flickering, repeat the above steps
4 and 5 to program all the commands you want
to the buttons on this remote control under the
same device mode.
�To exit from the setting mode, press any of the
DEVICE buttons.
7.
Repeat the above steps 1 to 6 to program the
commands from a different remote control.
8.
Operate the newly programmed buttons to make
sure the learning function was performed
properly.
22