Sherwood NewCastle R-772 Operating Instructions Manual page 31

R-772(A) 2007.8.20 10:2 AM 페이지 31
When CD, AUX, VIDEO 1~ 4 is selected as
an input source
• If the AUDIO MODE is set to the mode other
than "DIGITAL" for the corresponding input
source on the INPUT SETUP menu, you cannot
hear the sound from the selected digital input.
(For details, refer to "SETTING THE INPUT
SETUP" on page 53.)
4.
Press the AUDIO ASSIGN button.
• "AUD ~ " is displayed for several seconds.
• "AUD ~ " disappears, press the AUDIO ASSIGN
button again.
5.
Select the desired of the digital inputs connected
while displaying "AUD ~ ".
• Each time the MULTI CONTOL knob is rotated or
the CURSOR LEFT(◀)/RIGHT(▶) buttons are
pressed, the corresponding input is selected as
follows :
■Notes:
• When the selected digital input is not connected
or assigned, "o1", "c1", etc (, meaning no digital
signal input from it) or "d"(, meaning no audio
assignment) flickers and no sound will be heard.
• The selected digital input is automatically
assigned to the corresponding input source on
the INPUT SETUP menu. (For details, refer to
"SETTING THE INPUT SETUP" on page 53.)
• The sound from the component connected to the
selected digital input can be heard regardless of
the selected input source.
6.
Operate the selected component for playback.
• When playing back the program sources with
surround sound, refer to "ENJOYING
SURROUND SOUND" on page 34.
7.
Adjust the (overall) volume.
Muting the sound
• "MUTE" flickers.
• To resume the previous sound level, press it again.
Listening with headphones
• Ensure that the SPEAKER button is set to off.
• Depending on the signal format which is being
input, you can listen in Dolby Headphone mode,
stereo mode, etc. (For details, refer to "Listening
in Dolby Headphone mode" on page 35).
• When the EXTERNAL IN is selected as an input
source, only front left and front right channel
signals can be reproduced through the
headphones.
■Note:
• Be careful not to set the volume too high when
using headphones.
31