Port Configuration; Displaying Connection Status; Figure 3-47. Creating An Ip Filter List - SMC Networks TigerSwitch SMC6128PL2 Management Manual

C
ONFIGURING THE
CLI – This example allows SNMP access for a specific client.
Console(config)#management snmp-client 10.1.2.3
Console(config)#end
Console#show management all-client
Management IP Filter
HTTP-Client:
Start IP address
-----------------------------------------------
SNMP-Client:
Start IP address
-----------------------------------------------
1. 10.1.2.3
TELNET-Client:
Start IP address
-----------------------------------------------
Console#

Port Configuration

Displaying Connection Status

You can use the Port Information or Trunk Information pages to display
the current connection status, including link state, speed/duplex mode,
flow control, and auto-negotiation.
Field Attributes (Web)
• Name – Interface label.
• Type – Indicates the port type. (100BASE-TX, 1000BASE-T, or SFP)
• Admin Status – Shows if the interface is enabled or disabled.
• Oper Status – Indicates if the link is Up or Down.
• Speed Duplex Status – Shows the current speed and duplex mode.
(Auto, or fixed choice)
• Flow Control Status – Indicates the type of flow control currently in
use.
(IEEE 802.3x, Back-Pressure or None)
• Autonegotiation – Shows if auto-negotiation is enabled or disabled.
3-108
S
WITCH

Figure 3-47. Creating an IP Filter List

End IP address
End IP address
10.1.2.3
End IP address
4-38