Displaying Mvr Interface Status; Figure 3-104. Mvr Global Configuration - SMC Networks TigerSwitch SMC6128PL2 Management Manual

C
ONFIGURING THE
CLI – This example first enables IGMP snooping, enables MVR globally,
and then configures a range of MVR group addresses.
Console(config)#ip igmp snooping
Console(config)#mvr
Console(config)#mvr group 228.1.23.1 10
Console(config)#

Displaying MVR Interface Status

You can display information about the interfaces attached to the MVR
VLAN.
Field Attributes
• Type – Shows the MVR port type.
• Oper Status – Shows the link status.
• MVR Status – Shows the MVR status. MVR status for source ports is
"ACTIVE" if MVR is globally enabled on the switch. MVR status for
receiver ports is "ACTIVE" only if there are subscribers receiving
multicast traffic from one of the MVR groups, or a multicast group has
been statically assigned to an interface.
3-240
S
WITCH

Figure 3-104. MVR Global Configuration

4-270
4-283
4-283