Address Table Commands - SMC Networks TigerSwitch SMC6128PL2 Management Manual

Address Table Commands

These commands are used to configure the address table for filtering
specified addresses, displaying current entries, clearing the table, or setting
the aging time.
Address Table Commands
Command
mac-address-table
static
clear
mac-address-table
dynamic
show
mac-address-table
mac-address-table
aging-time
show
mac-address-table
aging-time
mac-address-table static
This command maps a static address to a destination port in a VLAN. Use
the no form to remove an address.
Syntax
mac-address-table static mac-address interface interface
vlan vlan-id [action]
no mac-address-table static mac-address vlan vlan-id
- mac-address - MAC address.
- interface
• ethernet unit/port
- unit - Stack unit. (Always unit 1)
- port - Port number. (Range: 1-52)
• port-channel channel-id (Range: 1-8)
- vlan-id - VLAN ID (Range: 1-4094)
4-188
Function
Maps a static address to a port in a VLAN
Removes any learned entries from the
forwarding database
Displays entries in the bridge-forwarding
database
Sets the aging time of the address table
Shows the aging time for the address table
Mode Page
GC 4-188
PE 4-189
PE 4-190
GC 4-191
PE 4-191