Logging Trap - SMC Networks TigerSwitch SMC6128PL2 Management Manual

C L
OMMAND INE
Command Usage
The command specifies the facility type tag sent in syslog messages.
(See RFC 3164.) This type has no effect on the kind of messages
reported by the switch. However, it may be used by the syslog server to
sort messages or to store messages in the corresponding database.
Example
Console(config)#logging facility 19
Console(config)#

logging trap

This command enables the logging of system messages to a remote server,
or limits the syslog messages saved to a remote server based on severity.
Use this command without a specified level to enable remote logging. Use
the no form to disable remote logging.
Syntax
logging trap [level]
no logging trap
level - One of the level arguments listed below. Messages sent
include the selected level up through level 0. (Refer to the table on
page 4-61.)
Default Setting
• Enabled
• Level 6 - 0
Command Mode
Global Configuration
Command Usage
• Using this command with a specified level enables remote logging and
sets the minimum severity level to be saved.
• Using this command without a specified level also enables remote
logging, but restores the minimum severity level to the default.
4-64
I
NTERFACE