Vlan Commands; Gvrp And Bridge Extension Commands - SMC Networks TigerSwitch SMC6128PL2 Management Manual

VLAN Commands

A VLAN is a group of ports that can be located anywhere in the network,
but communicate as though they belong to the same physical segment.
This section describes commands used to create VLAN groups, add port
members, specify how VLAN tagging is used, and enable automatic
VLAN registration for the selected interface.
VLANs
Command Groups Function
GVRP and
Bridge Extension
Editing VLAN
Groups
Configuring VLAN
Interfaces
Displaying VLAN
Information
Configuring Private
VLANs
Configuring Protocol
VLANs

GVRP and Bridge Extension Commands

GARP VLAN Registration Protocol defines a way for switches to
exchange VLAN information in order to automatically register VLAN
members on interfaces across the network. This section describes how to
enable GVRP for individual interfaces and globally for the switch, as well
as how to display default configuration settings for the Bridge Extension
MIB.
Configures GVRP settings that permit automatic
VLAN learning; shows the configuration for bridge
extension MIB
Sets up VLAN groups, including name, VID and
state
Configures VLAN interface parameters, including
ingress and egress tagging mode, ingress filtering,
PVID, and GVRP
Displays VLAN groups, status, port members, and
MAC addresses
Configures private VLANs, including uplink and
downlink ports
Configures protocol-based VLANs based on frame
type and protocol
VLAN C
OMMANDS
4-217
Pag
e
4-21
7
4-22
3
4-22
5
4-23
3
4-23
4
4-24
3