Mapping Cos Values To Egress Queues; Figure 3-88. Port Priority Configuration - SMC Networks TigerSwitch SMC6128PL2 Management Manual

C
ONFIGURING THE
CLI – This example assigns a default priority of 5 to port 3.
Console(config)#interface ethernet 1/3
Console(config-if)#switchport priority default 5
Console(config-if)#end
Console#show interfaces switchport ethernet 1/3
Information of Eth 1/3
Broadcast threshold:
LACP status:
Ingress rate limit: enable, K bits per second: 25
VLAN membership mode:
Ingress rule:
Acceptable frame type:
Native VLAN:
Priority for untagged traffic: 5
GVRP status:
Allowed VLAN:
Forbidden VLAN:
Private-VLAN mode:
Private-VLAN host-association: NONE
Private-VLAN mapping:
Console#

Mapping CoS Values to Egress Queues

This switch processes Class of Service (CoS) priority tagged traffic by
using four priority queues for each port, with service schedules based on
strict or Weighted Round Robin (WRR). Up to eight separate traffic
3-206
S
WITCH

Figure 3-88. Port Priority Configuration

Enabled, 500 packets/second
Disabled
Hybrid
Enabled
All frames
1
Disabled
1(u),
NONE
NONE
4-156
4-249
4-168