Installation
3.2
Quick Setup
Table 3-1 gives a quick overview of the VX-2 installation process. The sections following
this one provide detailed instructions.
Installation should be performed by a qualified custom video
Note
installation specialist.
Table 3-1. Installation Overview
Step
Choose a location for the projector
1
Install CineWide lens mounting assembly (stationary base
2
plate or AutoScope lens motor – optional)
Mount the projector
3
Connect the DHD Controller to the projector
4
Connect signal sources to the DHD Controller
5
Connect external controller to RS-232 port (optional)
6
Connect 12-volt trigger outputs to AutoScope lens motor
7
and/or other equipment (optional)
Connect projector, DHD Controller and lens motor (if
8
present) to AC power and power up
For rear-screen and/or ceiling-mount installations, select
9
the proper picture orientation
Primary lens adjustments: projected image size (zoom),
10
position (shift) and focus
Install CineWide anamorphic lens (optional)
11
CineWide lens adjustments: position, pitch (angle),
12
geometry and focus
Projector calibration: adjust the following for each input,
starting with Component SD; save settings when finished:
• Aspect ratio
• Brightness
13
• Contrast
• Color level
• Tint
• Input position
Procedure
18
Runco VX-2cx/VX-2dcx Owner's Operating Manual
For Details, Refer to
page...
19
25
28
29
30
34
35
36
37
22, 38
39
42
47