Connecting 12-Volt Trigger Outputs To External Theater Equipment; Rear Panel; Dhd Controller Rear Panel - Runco Video Xtreme VX-2cx User Manual

If your VX-2 is equipped with a CineWide with AutoScope system, connect the AutoScope
lens motor to a 12-volt trigger output on the DHD Controller; see Figure 3-14.
Similarly connect other 12-volt trigger-activated equipment (such as retractable screens or
screen masks) to the other trigger outputs.
For more information on using the DHD Controller triggers, refer to Triggers on page 59.
AutoScope Lens Motor (Rear)
Power
AC Input
Switch
3.5-mm
mini plug
Retractable Screen or other Serial No
12-volt trigger-activated Runco International
Union City, CA
device
Model
OUTPUTS
R/Pr G/Y B/Pb
Video Processor / Controller
H V H/V DVI Out
Figure 3-14. 12-Volt Trigger Output Connections
Runco VX-2cx/VX-2dcx Owner's Operating Manual
INPUTS
R/Pr G/Y B/Pb H V
Sleeve = Ground
HD1
Tip = +12V
HD2
R/Pr G/Y B/Pb H V
SDI
Pb Pr
DVI 1 DVI 2 Option Component Video
DHD Controller

Rear Panel

SYSTEM CONTROL INTERFACE
RISK OF ELECTRIC SHOCK
AVIS: RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR
TRIGGERS
CAUTION: TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE COVER. NO USER-
SERVICEABLE PARTS INSIDE. REFER SERVICING
TO QUALIFIED SERVICE CENTER.
1 2 3 IR
WARNING:
TO REDUCE THE RISK OF FIRE
OR ELECTRIC SHOCK, DO NOT EXPOSE
THIS APPLIANCE TO RAIN OR MOISTURE.
Y S-Video 1
100-230VAC 50-60 Hz, 165 Watts Max
Video S-Video 2 RS-232 Out RS-232 Control
35
Connecting 12-Volt
Trigger Outputs to
External Theater
Equipment
CAUTION !
DO NOT OPEN
Made In USA
Installation