Runco Video Xtreme VX-2cx User Manual page 56

Installation
Wrong Position
Once the proper lens angle has been set, firmly tighten the Yaw/X-Adjustment Levers to
secure the lens in place.
Adjusting the Geometry:
1. Input an anamorphic cross-hatch test pattern to the projector.
2. Loosen the Nylon Set Screws (item #2) just enough to allow the Anamorphic Lens to
rotate freely.
3. Grasp the lens by the center ring and rotate the lens until the image is properly
anamorphic:
Wrong Position
4. When the image geometry appears correct, tighten the set screws
to secure the lens in place. (When viewed from the front, the rear
opening on the anamorphic lens should appear as a tall, narrow
oval.)
Focus: Finally, rotate the Focus Ring on the anamorphic
lens to fine-tune the optical focus.
44 Runco VX-2cx/VX-2dcx Owner's Operating Manual
Correct Position
Correct Position