Using Speed-Dial Numbers - Muratec MFX-2500 Operating Instructions Manual

Beyond the Basics
One-touch fax dialing
To dial a fax call using a one-touch number:
1
Place the document and select resolution and contrast you require.
2
Toggle between transmission from the feeder or from memory if necessary, by
pressing
MEMORY TRANSMIT
3
Press the one-touch key in which you've stored the number.
One-touch phone dialing
To dial a phone call using a one-touch number, you must have an optional handset
attached to your machine. (Contact your authorized Muratec dealer to order an
optional handset.)
To make the call:
1
Obtain a dial tone by doing one of the following:
• Lift the handset
• Press / to use the monitor speaker
MONITOR CALL
2
Press the one-touch key in which you've stored the phone number.
Note: Remember that your fax machine's monitor speaker is not a speakerphone.
If you dialed by using the monitor speaker, pick up the handset to speak to
the person that answers.
Note: If the call fails, and you used
hang up.
2.4
.
/ to dial, press
MONITOR CALL MONITOR

Using speed-dial numbers

Your fax machine can store up to 222 speed-dial numbers, designated by three-digit
identifier codes from 001 through 222.
Entering or changing a speed-dial number
1
Press
MENU
The shows the speed-dial number list.
LCD
2
Select the speed-dial number in which you
want to store a number or change a previ-
ously stored number.
Note: You can select the speed-dial number
by directly entering that three-digit
identifier code. When entering the identifier code for speed-dial num-
bers less than 100, you must enter leading zeroes to make three digits.
For example, 001-099.
Note: You can press [Detail] to see the number which has been pro-
grammed in that speed-dial number.
3
Press [Enter].
4
Use the numeric keypad to enter the number
exactly as your machine should dial it, includ-
/ to
CALL
ing whatever access codes your phone system
requires. (You may want to review "Special
dialing characters," page 2.1.) The number
can be up to 40 characters in length.
Note: You must enter the fax number to program the speed-dial number.
Note: If a fax number is already registered in this speed-dial number, the
number is shown on the
press the [Clear] to erase it and then enter another number.
Note: If want to erase characters, press [Clear] to erase to the left.
If you want to change just one character in the number, move the cur-
sor to that character, and press [Clear] to erase it. Then re-enter the
character correctly.
5
When the number is as you want it, press [Enter] to store it.
, , [Enter].
B
. If you wish to change the fax number,
LCD