Sr6004 Remote Controller Macro Mode - Marantz SR5004 User Manual

ENGLISH
ADVANCED OPERATION
SR6004 REMOTE CONTROLLER
MACRO MODE
PROGRAMMING MACROS
Macros make it possible to use a single function
button to perform more complex series of
operations that would normally require pressing
several buttons.
A single MACRO can be programmed to perform up
to 10 steps in sequence.
A typical example of such a series might be as
follows:
• Turn this unit's power on
↓
• Switch this unit's input source to DVD
↓
• Turn the TV's power on
↓
• Set the DVD player to play.
• No signals may be transmitted during macro
programming.
• The various steps that make up a macro are
set initially to be sent one after another in 1
second intervals, however these intervals may
be shortened to as little as 0.5 seconds or
lengthened to as much as 5 seconds using the
setup mode.
• In the macro mode, the number of steps the
macro is displayed with Macro list number.
• Macros may be programmed 6 list.
MACRO button + numeric button (Example :
Macro list No.1 → MACRO button + "1")
72
PROGRAM METHOD OF MACRO
1.
3.
4.
3.
1.
2.
1.
Press and hold the SET and MACRO button
until the LEARN, MACRO indicators and
MACRO are displayed blinking on the LCD.
2.
Press the numeric button for which you
wish to program a series of operations.
Press the 1 button.
• "M1-01" is displayed on the LCD.
• If selected macro number has already
been set the program, the LCD will
blink.
3.
Press the function buttons and command
button for the operations you wish to
program as a macro in the sequence.
For example, press DVD button and 2
button.
Press DVD Button (DVD Function)
↓
Press 2 Button (Fixed 1st step)
• The number of steps in the macro is displayed on
LCD and this number increases by 1 with each
button pressed.
• Each macro number can be programmed to
perform up to 10 steps in sequence.
Note
When programing the amplifi erʼs input source in
the macro program, fi rst press the AMP button, and
press the source button.
(In the case of DVD input: AMP → DVD)
4.
When you are finished programming
macros, press and hold the ENTER
button until the display returns to normal
mode (Turn off the LEARN and MACRO
indicators).
• In the macro mode, it is possible to
program the memory to perform macros
containing up to 10 steps.
• Macros cannot be programmed for the
MEMO, cursor, ENTER, VOLUME+/– and
CLR buttons.
Note
If, while programming, no buttons are pressed for
approximately 1 minute, the remote controller will
automatically return to normal mode, and no macro
will be programmed in the memory.
CONFIRMING MACROS
Macros may be confirmed using following
procedure.
3.
5.
1.
1.
2.
1.
Press and hold the MACRO and MENU
buttons until the LEARN, MACRO indicators
and MACRO are displayed blinking on the
LCD.
2.
Press the numeric button to be confi rmed.
Let's use the example of macro number 1,
by pressing "1" button.
• LEARN, MACRO indicators and M1-01
are displayed blinking.
3.
Press the VOLUME button.
• M1-01 is displayed and LEARN is
disappeared.
• T h e p r o g r a m m e d o p e r a t i o n i s
transmitting.