Marantz SR5004 User Manual page 72

ENGLISH
ADVANCED OPERATION
CHECKING THE CODE
1.
1.
1.
Press and hold down the SOURCE button
for appliance which should be controlled
and press SET button until the
blinking twice then back light fl ushes.
2.
Press the INFO button.
The indicator will blink twice.
3.
To setup code for all digits is displayed on
the LCD in 3 seconds.
70
RESETTING THE CODE
2.
3.
4.
1.
Press and hold down the SOURCE button
for appliance which should be controlled
and press SET button until the
indicator
blinking twice.
Then back light fl ushes.
2.
Press the below codes to reset.
TV : 1000
DVD : 2000
CD : 3000
DSS : 4000
BD : 5000
Note
After this procedure, the selected SOURCE button
is set initial code.
LEARN MODE
This remote controller is capable of learning and
1.
storing codes used by other remote controls that
you already own.
For codes which are not learned, the remote
1. controller will transmit either the Marantz preset
codes from the initial settings, or remote codes
from another manufacturer's AV equipment which
is set by the customer.
The receiver sensor for the remote controller signals
2.
is located at the top of the remote controller.
Notes
• This remote controller is capable to learn around
160 codes.
• When the batteries are getting weak , the learning
indicator
procedure is not successful.
LEARNING PROCEDURE
1.
Place the remote controller so that its
infrared signal transmitter is facing the
infrared signal receiver on the Marantz
remote controller at a distance of about 5
cm (2 inches).
2.
Press and hold down the SET and SETUP
buttons until LEARN indicator blinks.
3.
Select the SOURCE button to select the
SOURCE, the SOURCE name is displayed
on the LCD.
4.
Select the button to be learned.
• LEARN indicator stop to blink.
Notes
• The learning function is unavailable for all
SOURCE buttons and HDMI button in any
mode.
• The learning function is unavailable for all
buttons in TUNER mode, USB mode, M-XP mode
and AMP mode.
5.
Press and hold the button of the original
remote controller to learn until "OK" is
displayed on the LCD.
• When "NG" is displayed on the LCD,
repeat this step.
• When the memory of the remote
controller is full, "FULL" is displayed on
the LCD. If you want to learn the code,
you should erase other learned button.
6.
Repeat steps 4 and 5 to learn other buttons
in same SOURCE.
7.
3 6
Repeat steps to to learn other
SOURCE.